Configuring GTP Flow
Was this helpful?
Was this helpful?
Command
gtp no gtp
Description
Global GTP Parsing
Parameters
None
Mode
EXEC
Using the following commands, you can configure a rule with GTP packet qualifiers to monitor the packets.
GTP and UDF can not be configured together on a device
Command
rule <ruleid> ( permit ) [description <cstring>] [gtp <gtpexpression> ] [counters (enable | disable)]
no rule <ruleid>
Description
Rule Configuration
Parameters
ruleid: It should be in the range 1 to 6000 description: max 50 characters.
gtp Example qualifiers: teid - Tunnel ID, match-all-ipv4 - Match all inner IPv4, match-all-ipv6 - Match all inner IPv6 ,inner-sip - Inner IP Source Address, inner-dip - Inner IP Destination Address, inner-protocol - Inner Header Protocol, inner_l4srcport - Inner Header UDP Source Port, inner_l4destport - Inner Header UDP Destination Port
Mode
FLOW
To verify flow, use the following command: