Configuring Network Ports

Network ports are the source port(s) that can be specified in a flow for matching and filtering on one or more ingress traffic ports.

Reference

Command

network-ports <network-ports>

Description

Configure network or TAP ports

Parameters

network-ports—valid interfaces, delimited by (,)

Mode

FLOW

CLI Example

pbnoscli# configure terminal 
pbnoscli(config)# flow flow01
pbnoscli(config-flow-flow01)# network-               
  network-ports         Configure network or TAP ports
pbnoscli(config-flow-flow01)# network-ports Ethernet1/1,Ethernet2/1
pbnoscli(config-flow-flow01)# 

You can verify the configuration by using the command(s) below:

pbnoscli# show flow flow01

===================================
Flow : flow01 (CLI)
===================================
Status       : enable          
Network-Port : Ethernet1/1,Ethernet2/1
pbnoscli# 
pbnoscli# show running-config 
configure terminal
!
interface ethernet Ethernet1/1
forward-error-correction rs
type network
!
interface ethernet Ethernet2/1
forward-error-correction rs
type network
!
interface mgmt
ip address 10.4.4.53/23 gateway 10.4.4.1
!
flow flow01
network-ports Ethernet0,Ethernet4
!
pbnoscli#