Configuring GTP
Last updated
Was this helpful?
Last updated
Was this helpful?
Command
gtp no gtp
Description
Global GTP Parsing
Parameters
None
Mode
EXEC
Using the following commands, you can configure a rule with GTP packet qualifiers to monitor the packets.
GTP and UDF can not be configured together on a device
Command
rule <ruleid> ( permit ) [description <cstring>] [gtp <gtpexpression> ] [counters (enable | disable)]
no rule <ruleid>
Description
Rule Configuration
Parameters
ruleid: It should be in the range 1 to 6000 description: max 50 characters.
gtp Example qualifiers: teid - Tunnel ID, match-all-ipv4 - Match all inner IPv4, match-all-ipv6 - Match all inner IPv6 ,inner-sip - Inner IP Source Address, inner-dip - Inner IP Destination Address, inner-protocol - Inner Header Protocol, inner_l4srcport - Inner Header UDP Source Port, inner_l4destport - Inner Header UDP Destination Port
Mode
FLOW
To verify flow, use the following command: