Configuring Tool Ports

You can specify the destination(s) for packets matching the flow. The supported destinations are as follows:

• port-id(s): matching traffic redirected to one or more tool ports

• port-channel: matching traffic redirected to multiple tool ports with symmetric load balancing

Reference

Command	tool-ports <tool-ports>
Description	Configure network tool or analyzer ports
Parameters	tool-ports—valid interfaces, delimited by (,)
Mode	FLOW

Example

pbnoscli# configure terminal 
pbnoscli(config)# flow flow01
pbnoscli(config-flow-flow01)# network-ports Ethernet1/1,Ethernet2/1
pbnoscli(config-flow-flow01)# tool-      
  tool-ports            Configure network tool or analyzer ports
pbnoscli(config-flow-flow01)# tool-ports port-channel1,Ethernet8/1
pbnoscli(config-flow-flow01)#

You can verify the configuration by using the command(s) below:

pbnoscli# show flow flow01

===================================
Flow : flow01 (CLI)
===================================
Status       : enable          
Network-Port : Ethernet1/1,Ethernet2/1
Tool-Port    : port-channel1,Ethernet8/1
pbnoscli# 

pbnoscli# show running-config 
configure terminal
port-channel 1 ports Ethernet63/1,Ethernet64/1
!
interface ethernet Ethernet1/1
forward-error-correction rs
type network
!
interface ethernet Ethernet2/1
forward-error-correction rs
type network
!
interface mgmt
ip address 10.4.4.53/23 gateway 10.4.4.1
!
flow flow01
network-ports Ethernet1/1,Ethernet2/1
tool-ports port-channel1,Ethernet8/1
!
pbnoscli#