Configuring Egress Tagging

You can use the egress tagging functionality to add a VLAN tag to the packet transmitted from the tool port.

Reference

Command	{no} egress-tagging enable
Description	Egress-tagging configuration
Parameters	None
Mode	INTERFACE

This feature should only be configured on Tool ports

Example

pbnoscli# configure terminal 
pbnoscli(config)# interface ethernet Ethernet4/1
pbnoscli(config-if)# egress-        
  egress-tagging        Add egress tagging
pbnoscli(config-if)# egress-tagging enable 
pbnoscli(config-if)# 

You can verify the configuration by using the command(s) below:

pbnoscli# show interface npb Ethernet4/1

===================================
Interface : Ethernet4/1       
===================================
Type           : tool            
Mode           : vlan-aware      
Ingress-vlan   : 6               
Egress-tagging : enable          
Loopback-mode  : disable         

pbnoscli# 

pbnoscli# show running-config 
configure terminal
!
interface ethernet Ethernet4/1
type tool
egress-tagging enable
mode vlan-aware
!
interface mgmt
ip address 10.4.4.53/23 gateway 10.4.4.1
!
pbnoscli#