Configuring Tx-only

Tx-Only

You can use the Tx-only functionality to have only a Transmit link on the tool ports

This feature is only supported on Broadcom platforms

Reference

Command	{no} transmit-only
Description	Tx-only configuration
Parameters	None
Mode	INTERFACE

Example

pbnoscli# configure terminal 
pbnoscli(config)# interface ethernet Ethernet4/1                  
pbnoscli(config-if)# tr            
  transmit-only         Activate tx-only mode
pbnoscli(config-if)# transmit-only 
pbnoscli(config-if)# end

You can verify the configuration by using the command(s) below:

pbnoscli# show interface npb Ethernet4/1
===================================
Interface : Ethernet4/1
===================================
Ingress-vlan   : 18
Egress-tagging : disable
Transmit-only  : enable

pbnoscli#

pbnoscli# show running-config 
configure terminal
interface ethernet Ethernet4/1
transmit-only
!
interface mgmt
ip address 10.4.4.53/23 gateway 10.4.4.1
!
pbnoscli#