Configuring GTP Flow

GTP

Enable GTP Parsing

Reference

Command

gtp no gtp

Description

Global GTP Parsing

Parameters

None

Mode

EXEC

Example

GTP Rule Match For Inner Headers

Using the following commands, you can configure a rule with GTP packet qualifiers to monitor the packets.

  • Before configuring rules, network and tool ports must be configured.

  • GTP must be enabled in config mode.

Reference

Command

rule <ruleid> ( permit ) [description <cstring>] [gtp <gtpexpression> ] [counters (enable | disable)]

no rule <ruleid>

Description

Rule Configuration

Parameters

ruleid: It should be in the range 1 to 6000 description: max 50 characters.

gtp Example qualifiers: teid - Tunnel ID, match-all-ipv4 - Match all inner IPv4, match-all-ipv6 - Match all inner IPv6 ,inner-sip - Inner IP Source Address, inner-dip - Inner IP Destination Address, inner-protocol - Inner Header Protocol, inner_l4srcport - Inner Header UDP Source Port, inner_l4destport - Inner Header UDP Destination Port

Mode

FLOW

Example

To verify flow, use the following command:

Last updated