Configuring Packet Slicing

You can use packet truncation, which is a unique capability available only on NVIDIA platforms, to truncate the packets which are sent to the tool. This helps tools reduce the storage capacity needed for saving packets for future analysis. It truncates the packet for the given offset.
This feature is only supported on the NVIDIA platforms
Reference
Command
truncate <offset value>
no truncate
Description
Truncate packets after offset
Parameters
Offset-value – multiple of 4 within 48 to 4088
Mode
INTERFACE
Example
pbnoscli# configure terminal
pbnoscli(config)# interface ethernet Ethernet4/1
pbnoscli(config-if)# trunc
truncate Truncate the packet
pbnoscli(config-if)# truncate 64
You can verify the configuration by using the command(s) below:
pbnoscli# show interface npb Ethernet4/1
===================================
Interface : Ethernet4/1
===================================
Mode : vlan-aware
Ingress-vlan : 6
Egress-tagging : disable
Truncate : 64
pbnoscli#
pbnoscli# sh running-config
configure terminal
!
interface ethernet Ethernet4/1
truncate 64
!
interface mgmt
ip address 10.4.4.53/23 gateway 10.4.4.1
!
pbnoscli#
Last updated
Was this helpful?