Configuring inband Management

In-band management means the APB device can be configured, monitored, and accessed via the same network interfaces used for data plane traffic, making it flexible for deployments without dedicated management ports.

This feature is only supported on Dell TD3 5232 and 5248 platforms

To configure the inband management in interface, use the following command:

pbnoscli# configure terminal 
pbnoscli(config)# interface ethernet Ethernet4/1
pbnoscli(config-if)# ip address 21.21.21.1/24
pbnoscli(config-if)# ip address 40.10.1.14/24
pbnoscli(config-if)# inband-mgmt
  enable                Enable
pbnoscli(config-if)# inband-mgmt enable
  <cr>
pbnoscli(config-if)# inband-mgmt enable 

pbnoscli# configure terminal 
pbnoscli(config)# int port-channel 5
pbnoscli(config-if)# ip address 31.31.31.1/24
pbnoscli(config-if)# ip address 50.10.1.14/24
pbnoscli(config-if)# inband-mgmt
  enable                Enable
pbnoscli(config-if)# inband-mgmt enable
  <cr>
pbnoscli(config-if)# inband-mgmt enable
pbnoscli(config-if)#

You can verify the configuration by using the command(s) below:

pbnoscli# show running-config 
!
interface ethernet Ethernet4/1
mtu 9100
speed 100000
inband-mgmt enable
forward-error-correction none
!

!
port-channel 5 ports Ethernet5/1 lacp min-links 1
!
interface port-channel 5
inband-mgmt enable
!
pbnoscli#