Configuring Systems Parameters

To configure and manage system attributes of ASN via the FlowVision GUI, navigate to:

Configuration > Systems.

The Systems Manager page shows the Kafka, SNMP, NTP, and Syslog configurations, this page allows users to add or remove IP addresses associated with these configurations.

The following image shows the System Parameters page:

Flow Manager

Kafka Configurations

Configure and manage up to one Kafka server IP address for exporting metadata extracted by the Service Node.

SNMP Trap Configuration

Configure and manage up to three SNMP trap server IP addresses for receiving SNMP traps generated by the Service Node.

NTP Configuration

Configure and manage up to three NTP server IP addresses for time synchronization.

Syslog Configuration

Configure and manage up to three Syslog server IP addresses for receiving system logs from the Service Node.

SNMP Trap Threshold

Set thresholds for SNMP traps based on the following parameters:

• Disk Usage (%): Define a trigger when disk utilization exceeds a specified percentage.

• CPU Usage (%): Set a threshold for CPU utilization percentage.

• Temperature (℃): Configure the ASN appliance temperature limit before an SNMP trap is triggered.

• Memory Usage (%): Specify the threshold for memory consumption.

• FAN RPM (%): Set a limit for fan speed in Revolutions Per Minute (RPM).