Configuring Strip-Vlan

Strips the Outer Vlan header in the Packet at the ingress stage itself.

This is needed when the original packet from TAP should be retained and Vlan added by APB AGG should be removed. Also when the encap features are present the tag should be removed at the ingress stage itself before adding encap header.

Reference

Command	[no] strip-vlan enable
Description	strip-vlan configuration
Mode	INTERFACE

• This feature should only be configured on Network ports

• Both ingress-vlan and strip-vlan cannot co-exist on one interface

• Support in all TD3 BCM platforms

CLI Commands

pbnoscli# conf t pbnoscli(config)# interface ethernet Ethernet1/1 pbnoscli(config-if)# strip-vlan enable Enable pbnoscli(config-if)# strip-vlan enable