Configuring Tool Ports
You can specify the destination(s) for packets matching the flow. The supported destinations are as follows:
port-id(s): matching traffic redirected to one or more tool ports
port-channel: matching traffic redirected to multiple tool ports with symmetric load balancing
Reference
Configure network tool or analyzer ports
tool-ports—valid interfaces, delimited by (,)
Example
pbnoscli# configure terminal
pbnoscli(config)# flow flow01
pbnoscli(config-flow-flow01)# network-ports Ethernet1/1,Ethernet2/1
pbnoscli(config-flow-flow01)# tool-
tool-ports Configure network tool or analyzer ports
pbnoscli(config-flow-flow01)# tool-ports port-channel1,Ethernet8/1
pbnoscli(config-flow-flow01)#
You can verify the configuration by using the command(s) below:
pbnoscli# show flow flow01
===================================
Flow : flow01 (CLI)
===================================
Status : enable
Network-Port : Ethernet1/1,Ethernet2/1
Tool-Port : port-channel1,Ethernet8/1
pbnoscli#
pbnoscli# show running-config
configure terminal
port-channel 1 ports Ethernet63/1,Ethernet64/1
!
interface ethernet Ethernet1/1
forward-error-correction rs
type network
!
interface ethernet Ethernet2/1
forward-error-correction rs
type network
!
interface mgmt
ip address 10.4.4.53/23 gateway 10.4.4.1
!
flow flow01
network-ports Ethernet1/1,Ethernet2/1
tool-ports port-channel1,Ethernet8/1
!
pbnoscli#