Configuring VXLAN Flow
Modification to the Tunnel config or Tunnel-related Flow is not supported. However, you can delete the existing configuration and create a new one as needed.
Flow with Tunnel interface cannot have an 'override-to' action in the rule configuration
Configure Tunnel Flow only after the VxLAN tunnel is operationally 'UP' in the "show vxlan tunnel all/<tunnel-id>" output
Only 1 rule can be configured in tunnel-related flow
The current release doesn't support VxLAN tunnel over a LAG interface
For remote VxLAN-VTEP(Different subnet), the below order has to be followed for configuration
Tunnel Configuration
Tunnel Attributes
Using this command, you can configure the attributes of the tunnel. Gateway is provisioned only when the nodes are not directly connected
Note: Updation of the tunnel is not supported. The tunnel must be deleted and re-configured for any change
Flow based Encap Configuration
You can set the rules for the VxLAN Encap using flow. Here the tool port must be the tunnel name created using tunnel config command.
Flow-Based Decap Configuration
You can set the rules for the VxLAN Decap using flow.. Here the Network port must be the tunnel name created using tunnel config command.
Show VXLAN Tunnel Command
You can display the Vxlan tunnel configurations using this command.
